Reduction Kinetics of FeO in Electric Smelting Furnace (ESF) Slag for Alternative Hot Metal Production with Hydrogen-Reduced Iron Ore

초록

We investigated the effects of the representative gangue or refractory components MgO and Al2O3 on the FeO reduction mechanism and chemical reaction kinetics in synthetic slags simulating the upper part of an electric smelting furnace (ESF) at 1873 K (1600 degrees C) to produce hot metal using a hydrogen-reduced iron ore for CO2 mitigation. The experiments were conducted in a high-frequency induction furnace to facilitate the smelting reduction reaction, and the FeO reduction rate in the slag was analyzed through an in-situ off-gas analysis. Additionally, interval sampling was applied to observe changes in chemical composition of slag over time during smelting reduction. The experimental results revealed that the FeO reduction reaction in molten slag by solid carbon proceeded in three distinct stages in terms of chemical reaction kinetics: (i) incubation, (ii) steady state, and (iii) degradation. During the incubation period, the duration varied depending on the mass ratio of MgO to Al2O3, which was interpreted to be a result of the influence of the slag's physical properties on the nucleation and growth rate of bubbles around the carbon. In the steady state period, experiments using a magnesia refractory exhibited relatively higher reduction rates for all slag compositions, whereas those using an alumina refractory showed a lower reduction rate. This was attributed to the dissolution of Al2O3 from the refractory into the slag, where it acted as a network former, increasing the slag viscosity and slowing the reduction rate. The current study provides fundamental data for optimizing slag design to achieve rapid FeO reduction in ESF. Based on these findings, it is expected to contribute to improving Fe yield and enhancing slag sustainability.

키워드